Axis PS-24 Installationsanleitung Seite 6

Connect power to the PS-24
1. Remove the lid of the power supply by removing the 4 screws.
2. Make sure the power switch
Important!
The power switch does not break on both poles at the AC input. The power switch shall only be used to turn
the camera on/off. When the power switch is set to off, high voltage is still present in the AXIS PS-24
mains adaptor. Regard the switch in the building installation as disconnect device.
3. Make sure the voltage selector switch
correspond to the input mains voltage i.e.:
• set the switch to 115V if you intend to power the unit from a 100-120V mains
voltage line.
• set the switch to 230V if you intend to power the unit from a 220-240V mains
voltage line.
4. Remove the outer ring of the cable gland and the plug, thread the mains cable (not
supplied) through the outer ring and then through the cable gland.
5. Connect the live wires to AC Input
to secure the cable.
6. Refer to the installation section for your network camera for information on how to
connect the power and alarm inputs/outputs.
7. Check that the cables are securely tightened and that the voltage selector switch is in
the correct position.
Important!
Make sure the power switch
the installation is complete.
For unused cable glands, do not remove the plug and make sure that the outer ring is
tightened securely.
PS-24 Mains Adaptor
is set to '0' (off).
4
5
is in the correct position. The setting must
6
(230VAC or 115VAC). Tighten the outer ring
is set to '0' (off) until all cables have been connected and
4