Cleaning And Maintenance - Philips L'Or Barista Bedienungsanleitung

English
14

Cleaning and maintenance

Cleaning the used capsule drawer and waste water drawer
4 Press and hold the button of the coffee whose quantity you want to
adjust for 3 seconds until the button flashes quickly. Then release the
button. The machine starts brewing coffee.
5 Press the same button again when the cup contains the desired quantity
of coffee.
Note: If you press the coffee button too early, the machine programs the
minimum quantity of coffee shown in the table above. If you do not press
the coffee button, the machine programs the maximum quantity of
coffee.
Resetting the coffee quantities
To reset the coffee quantities to their factory settings:
1 Press the on/off button to switch on the machine.
2 Wait until the machine has heated up and all buttons light up.
3 Press and hold the ristretto, espresso and lungo buttons simultaneously
until all buttons flash quickly to show that the machine has been reset to
factory settings.
Check the used capsule drawer and waste water drawer regularly.
Note: For optimal hygiene, pull up the lever after use to ensure the last used
capsule falls into used capsule drawer.
1 Pull the used capsule drawer and the waste water drawer out of the
machine.
2 Remove the drip tray from the lower drip tray and rinse the drip tray and
the cup tray under a warm tap. Do not clean these parts in the
dishwasher.