Herunterladen Inhalt Inhalt Diese Seite drucken

Correct Disposal Of This Product; Gas Cylinder - Napoleon PRESTIGE 500 Handbuch

Vorschau ausblenden Andere Handbücher für PRESTIGE 500:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Correct Disposal Of This Product

This marking indicates that this product should not be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.

Gas Cylinder

Use only gas cylinders, which meet national and regional codes. For optimal performance the grill should
be operated on propane. The minimum cylinder size for butane units is 13kg, and for propane units is 6kg.
Ensure that the cylinder can provide enough fuel to operate the appliance. If in doubt, check with your
local gas supplier.
Use caution when handling the cylinder valve.
Never connect a cylinder, which does not meet local codes.
All cylinders larger than 310mm in diameter or 580mm in height must be placed outside the enclosure
on level ground. Cylinders with a diameter of 310mm or less and a height of 580mm or less may be
placed inside the enclosure on the right side of the bottom shelf.
Only cylinders connected to the appliance may be stored in the enclosure, or close to the appliance.
Spare cylinders must not be stored in the enclosure, or in close proximity of an operating unit.
Cylinders must not be exposed to extreme heat or direct sunlight.
!
WARNING!
unit. Hoses that contact high temperature surfaces may melt and leak, causing a fire.
Cylinder Connection: Ensure that the gas regulator hose is kink free. Remove the cap or plug from the
cylinder fuel valve. Tighten regulator to cylinder valve. Leak test all joints prior to using the barbecue. A
leak test must be performed annually, and each time a cylinder is hooked up, or if a part of the gas system
is replaced.
Example Cylinder
Diameter
Gas Hose
If the hose and regulator are not included by the manufacturer, then only hoses and regulators which
meet national and regional codes are to be used.
Ensure that the hose does not come into contact with grease, other hot drippings, or any hot surfaces
on the appliance.
Check hose regularly. In the case of rips, melting or wear, replace hose before using the appliance.
The recommended hose length is 0.9m. The hose must not be longer than 1.5m.
Ensure that the hose is twist and kink free when installed.
Replace the hose before expiry date printed on the hose.
N415-0518CE-GB-DE AUG 05.20
Ensure that the hose is routed to maintain proper clearance to the underside of the
Height
5
EN
www.napoleon.com

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis