Playing the current tune repeatedly
You can play the current tune repeatedly (Repeat
Play).
1
Press MODE to enter the functions mode
while playing a tune you want to hear over
again on a cassette. This unit enters the
functions mode.
2
Press RPT (repeat), while still in the functions
mode, so that the RPT indicator lights up on
the display.
MODE
Lights up when Repeat Play is turned on.
When the tune has been played, the tape is
automatically rewound to the beginning of that
tune and the same tune will be played again.
To cancel Repeat Play, repeat steps 1 and 2
again so that the RPT indicator goes off.
Note:
In the following cases, Blank Skip and Repeat Play
may not operate correctly:
– Tapes with tunes having long pianissimo passages
(very quiet parts) or non-recorded portions during
tunes.
– Tapes with short non-recorded sections.
– Tapes with high level noise or humming between
tunes.
– Tapes with tunes recorded at low recording levels.
Prohibiting cassette ejection
You can prohibit cassette ejection and "lock" a
cassette in the cassette compartment.
Press and hold TAPE 23 and 0 (eject) for more
than 2 seconds.
11
RPT
"NO EJECT" flashes on the display for about 5
seconds, and the cassette is "locked."
To cancel the prohibition and "unlock" the
cassette, press and hold TAPE 23 and 0 (eject)
for more than 2 seconds again.
"EJECT OK" flashes for about 5 seconds, and this
time the cassette is "unlocked."
Note:
If you press 0 while cassette ejection is prohibited,
the cassette will not be ejected.
TAPE
19