JUNO JCF082F0F1 Benutzerinformation Seite 16

16
Problem
There is too much con‐
densed water on the rear
wall of the refrigerator.
Water flows inside the refrig‐
erator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
Food products prevent the
water from flowing into the
water collector.
The water outlet is clogged.
The melting water outlet is
not connected to the evapo‐
rative tray below the appli‐
ance.
The "FastCool function" is
switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The FastCool function is
switched on.
Solution
Open the door only when
necessary.
Make sure the door is
closed completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Make sure that food prod‐
ucts do not touch the rear
plate.
Clean the water outlet.
Attach the melting water out‐
let to the evaporative tray.
Switch off "FastCool func‐
tion" manually, or wait until
the function deactivates au‐
tomatically to set the tem‐
perature. Refer to "FastCool
function" section.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Refer to "FastCool function"
section.