Led Status Display - VOLTCRAFT DL-260A Bedienungsanleitung

Symbol Meaning
/
Ready to deactivate limit pause function by holding button ENTER (7) for few seconds.
Days, unit for remaining time. (If the remaining time is below one day, remaining time is shown in
HH:MM format.)
Ready to upgrade firmware.
Measurement error
Measured values are beyond the measuring range.
Configuration error. An error occurred during configuration. Repeat the configuration process.

8. LED status display

LED indicator
Green LED control light
(3) is flashing.
Red LED control light
(2) is flashing.
Red LED control light
(2) is continuously on.
Green LED control light
is flashing twice.
No LED light is on.
36
Description
Measured value(s) are within the configured limits of low and high alarm.
Memory is full.
Measured value(s) are exceeding configured limits of low and high alarm.
In mode "START UPON KEYPRESS" or "STOP TIME" recording has been terminated.
(In order to start recording again, re-configure data logger.)
In mode "START UPON KEYPRESS", data logger is ready to start recording.
(In order to start recording hold button ENTER (7) pressed for few seconds.)
Data logger is generating PDF report.
Configuration was successful.
Firmware has been updated successfully.
LED-alarm was disabled during configuration.