Scheppach Duo 7.0 Originalanleitung Seite 18

Error
Machine vibrates
Unclean cuts / wood burns
Fast wear and tear of tool
Motor heats up (one can no
longer touch it with bare hands,
it switches off constantly)
Machine stops
The wood is lifted high by the
rear part of the saw blade
Height adjustment of the spindle
is stiff
Machine vibrates
Unclean cuts / wood burns
D GB
Fast wear and tear of tool
Motor heats up (one can no
longer touch it with bare hands,
it switches off constantly)
Machine stops
Height adjustment of the spindle
is stiff
Error search plan
Possible cause
Clamping lever for height adjustment is not screwed tightly
Tool is not screwed tightly
Tool is blunt
Tool is not installed correctly
Tool is not sharpened correctly
Covered wood (cement, sand, nails)
Different causes possible
Feed is too fast
Tool is blunt
Longitudinal stop is not parallel
Splitting wedge not in adjustment or sewing is too weak
Threaded rod, toothed wheels, slide reals are polluted
Clamping lever is not loosened
Clamping lever for height adjustment is not screwed tightly
Tool is not screwed tightly
Tool is blunt
Tool is not installed correctly
Tool is not sharpened correctly
Covered wood (cement, sand, nails)
Different causes possible
Feed is too fast
Tool is blunt
Threaded rod, toothed wheels, slide reals are polluted
Clamping lever is not loosened
Remedy
Saw
Tighten clamping lever
Tighten tool
Use sharp tools only
Check correct installation of the tool
Have the tool re-sharpened correctly / install new tool
Use clean wood only
Get it checked by an electrician
Reduce feed
Use sharp tools only
Readjust longitudinal stop
Readjust splitting wedge
Clean and lubricate components
Check and loosen clamping lever
Milling machine
Tighten clamping lever
Tighten tool
Use sharp tools only
Check correct installation of the tool
Have the tool re-sharpened correctly / install new tool
Use clean wood only
Get it checked by an electrician
Reduce feed
Use sharp tools only
Clean and lubricate components
Check and loosen clamping lever
18