Fixation screw
position
Cutout 50 x 50 cm
Fixation screw
position
The oven may be housed either under a work surface or built into a co-
lumn that is open* or closed with a suitable opening.
Your oven works at its best and produces excellent results when cooking and
cleaning itself, if its air circulation is not compromised:
• The oven must be centred in the unit so that there is a minimum distan-
ce of 5 mm between it and the surrounding unit.
• The housing unit or its outer surface must be capable of withstanding
heat.
• To ensure the oven rests firmly in the housing, screw it to the housing unit
using the holes on the side uprights provided (see diagram).
To do this:
1) Remove the rubber stoppers masking the fixing holes.
2) To prevent the housing unit splintering, drill two holes 2 mm in diameter
in the wall of the housing unit opposite the fixing holes.
3) Attach the oven using the two screws.
4) Conceal the hole using the rubber stoppers. (These also help to
cushion the closing of the oven door).
(*) If the housing unit is open at the back, the gap must not be more
than 70 mm.
Installer's information
Housing
GB 47