Proxxon Micromot 230/E Originalbetriebsanleitung Seite 11

Translation of the Original
GB
Operating Instructions
Proxxon - Micromot 230/E
Dear customer!
Always keep these operating instructions and the
enclosed safety guidelines within reach.Only use
this device with exact knowledge of it and com-
ply with the instructions and safety guidelines!
This is necessary to ensure safe operation and,
secondly, it facilitates familiarisation with the
device and its functions.
Proxxon assumes no liability for the safe func-
tion of the device in the case of:
• handling that does not comply with normal
intended use,
• use for other purposes not mentioned in
the manual,
• incorrectly executed repairs,
• failure to heed safety instructions,
• external infl uences for which the
manufacturer is not responsible.
We recommend using PROXXON original spa-
re parts for all repair and maintenance work.
Repairs should only be performed by qualifi ed
skilled personnel!
Please note: All information contained in these
operating instructions - especially the technical
data - corresponds to the status at the time of
printing.
We reserve the right to make further develop-
ments in the interest of technical progress. We
wish you every success with the device.
Warning!
Read all safety wanings and inst-
ructions.
Failure to follow all safety warnings
and instructions listed below may re-
sult in electric shock, fi re and/or serious injury.
KEEP ALL SAFETY WARNINGS AND INSTRUC-
TIONS FOR THE FUTURE !
Safety instructions for all operations
Safety warnings common for grinding, san-
ding, wire brushing, polishing, carving or
abrasive cutting-off operations:
a) This power tool is intended to function
as a grinder, sander, wire brush, polisher,
carving or cut-off tool. Read all safety
warnings, instructions, illustrations and
specifications provided with this power
tool. Failure to follow all instructions listed
below may result in electric shock, fi re and/
or serious injury.
b) Do not use accessories which are not
specifically designed and recommended
by the tool manufacturer. Just because
the accessory can be attached to your po-
wer tool, it does not assure safe operation.
c) The rated speed of the grinding acces-
sories must be at least equal to the ma-
ximum speed marked on the power tool.
Grinding accessories running faster than
their rated speed can break and fl y apart.
d) The outside diameter and the thickness
of your accessory must be within the
capacity rating of your power tool. Incor-
rectly sized accessories cannot be adequa-
tely controlled.
e) The arbour size of wheels, sanding
drums or any other accessory must pro-
perly fit the spindle or collet of the pow-
er tool. Accessories that do not match the
mounting hardware of the power tool will
run out of balance, vibrate excessively and
may cause loss of control.
f) Mandrel mounted
drums, cutters or other accessories must
be fully inserted into the collet or chuck.
If the mandrel is insuffi ciently held and/or
the overhang of the wheel is too long, the
mounted wheel may become loose and be
ejected at high velocity.
wheels, sanding
- 13 -