Faults - What To Do - NEFF K846-Serie Gebrauchsanleitung

en Faults – what to do?
3
Faults – what to do?
Before you call customer service, use this table to check whether you can rectify
d o ? F a u l t s – w h a t t o
the fault yourself.
Temperature differs greatly from the set value.
Displays do not illuminate.
The mains plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display indicates "E...".
Electronics have detected a fault.
Appliance is not cooling, display and light are lit.
Demo mode switched on.
--------
36
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance"
on page 29
If the temperature is too warm, check temperature
again after a couple of hours.
If the temperature is too cold, check temperature
again on the following day.
Connect the mains plug.
Check the fuses.
Check whether the power is on.
Call the customer service.
~ "Customer service" on page 37
Hold down button Alarm for 10 seconds until an
acknowledgement signal sounds. Wait and check
whether the appliance is cooling.