Operation - Oase PondoVac Premium Gebrauchsanleitung

- EN -
5

Operation

1 Switching on/off
off: Unit is switched off
on: Unit is switched on
− The vacuum starts up.
− The discharge pump switches on when the max. water level is reached.
2 Switching on the motor (overload) protection switch
The motor (overload) protection switch switches off the discharge pump in the event of a blockage. (→ Malfunction
remedy)
− The unlock button pops out.
− To switch the discharge pump on again: Press the unlock button.
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
►
Isolate the device (disconnect from the power supply) before carrying out any work on it.
►
Only operate the unit if no persons are in the water.
►
N O T E
Never operate the unit without the filter element! The electronics will be destroyed.
How to proceed:
Plunge the extension wand with floating suction hose and nozzle into the water and vacuum the floor
•
of the pond/pool.
Clean the unit after each use. (→ Maintenance and cleaning)
•
Recommendation: Vacuum up clean water and empty the tank again. This will wash out the dirt
particles.
24
PVC0013