Operation; Maintenance - BGS technic 1609 Bedienungsanleitung

Note: Always secure threaded port connections with non-hardening pipe thread compound. Tighten
securely to prevent accidental removal of components while in use. Take care not to introduce
compound into port orifices. Familiarize yourself with the specifications and illustrations in this
operator's manual. Know your pump, its limitations and how it operates before attempting to use.
Refer to Specification chart on above for details of oil port thread size, usable oil capacity, and more.

OPERATION

1. Operation of the unit is as follows:
2. Connect the hose of the Air/Hydraulic Pump to the hydraulic coupling on the selected tool.
3. Connect the air supply line to the Air/Hydraulic Pump. Air supply should be 5- 10 CFM at 100 PSI
to obtain proper operating characteristics. In addition, the air line should be equipped with an air
line filter.
4. Stepping on the PUMP end of the pedal (no.2 in picture) engager the pump, producing the force
necessary to run the tool.
5. Depressing the RELEASE end of the pump pedal (no.1 in picture) will release the pressure.

MAINTENANCE


Inspect hoses and connections before using the hydraulic pump.

Tighten connections as needed. .

Use only good quality hydraulic fluid. We recommend Mobil DTE 13M or equivalent.
When not in use or during storage:

Depressurize the unit and disconnect hydraulic hoses from application.

Clean the unit with a soft and dry cloth.

Store in a clean and in a dry environment.

Avoid extremes high or low temperature.
Adding Hydraulic Fluid
1. Depressurize the unit and disconnect hydraulic hose from application.
2. Make sure that the pump is in upright, horizontal position.
3. Remove the oil filler plug (located on the top plate of the reservoir).
4. Use a small funnel to fill reservoir to within 3/4" (19mm) of the opening.
5. Never use brake fluid, transmission fluid, turbine oil, motor oil, alcohol, glycerin etc.
6. Use of other than good quality hydraulic oil will void warranty and damage the pump, hose, and
application.
7. Wipe up any spilled fluid and reinstall the oil filler plug.
Changing Hydraulic Fluid
1. For best results, change fluid once a year.
2. Remove the oil filler plug (located on the top plate of the reservoir) then pour used fluid into a
sealable container.
3. Dispose of fluid in accordance with local regulations.
4. Fill with a good quality hydraulic oil as recommended above. Reinstall vented oil filler plug.
Lubrication
Use a light machine oil to lubricate pivot points, hinges etc.
Note: Never operate pump with release valve closed and disconnected from application. If operated in
this condition, the hose and connections become pressurized. This increases burst hazard. Damage
may occur to pump and its components.
SW-Stahl und Werkzeugvertriebs GmbH
L e v e k r u s r e t S a r s s e 6 5
D 4 - 2 8 9 7 R e m s c h e d i
Tel. +49 (0) 2191 / 46438-0
F ax +49 (0) 2191 / 46438-40
- E M a : l i n i o f @ s w s a t l h d . e