Special Settings; Cleaning And Maintenance - EuroLite TMH-150 Bedienungsanleitung

Control channel 6 - Pan-movement with 16 Bit-resolution
This function is only available after the device has been switched to 16-bit-mode via the Function-DIP-
switches.
Control channel 7 - Tilt-movement with 16 Bit-resolution
This function is only available after the device has been switched to 16-bit-mode via the Function-DIP-
switches.

Special settings

Via the Function-DIP-switches, you can adjust different modes and settings:

CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) Mechanically moved parts like axles, eyes and others must not show any traces of wearing (e.g. material
abrading or damages) and must not rotate with unbalances.
4) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or
solvents!
The lens has to be replaced when it is obviously damaged,
so that its function is impaired, e. g. due to cracks or deep scratches!
The objective lens will require weekly cleaning as smoke-fluid tends to building up residues, reducing the
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
CAUTION!
29/58 51786400X51NXS_V_1_0.DOC