Musikhaus Kirstein Lacoon GA-40 Golden Age Bedienungsanleitung Seite 11

function, press "Auto" on the front panel to start searching and saving
the available radio frequencies. Once the saved radio frequency is
saved. Press "PRE+" or "PRE-" to select programmed station.
CD-Player: Press "Mode/DEV" button until LCD display indicate "----
", then display will show number of songs. For operation use
Start/Pause (>II), Stop, Next (>>I), Prev (I<<) and volume control.
Press "REP" once to repeat one song, the REP indication at the top
left corner on the led display will flash. Press "REP" one more time to
repeat all songs in the track and the REP indication at the top left
corner on the led display will appear. Press "REP" again to cancel
repeat function.
SD-Player / USB Player: Press "Mode/DEV" button until led display
indicate "SD----" resp. "USB----", then display will show number of
folder, then number of songs. For operation use Start/Pause (>II),
Stop, Next (>>I), Prev (I<<) and volume control. Press "Next/Prev" or
"F+/-10" to select your desire song. Press "REP" once to repeat one
song, the REP indication at the top left corner on the led display will
flash. Press "REP" one more time to repeat all songs in the track and
the REP indication at the top left corner on the led display will appear.
Press "REP" again to cancel repeat function. To play songs randomly,
press "REP" button until the led display "RAN" on the bottom of the
display. For programming, press "STOP" button to stop playback.
Press "PROG" to enter programming mode. The led display will flash
and indicate "P 01", select the song that you want to program and
then press "PROG" again. Press "Play/Pause" to stop programming
and start to playback the programmed songs. This unit can program
up to 20 songs.
Light Management: You can turn the lights on by pressing the button
5 (as seen above) on the frontside. To switch between the two light
modes, you have to operate the switch on the backside called "Light
Mode". If the switch is on "Play" the color will change repeatedly, if the
switch is on "Hold" the color will stay on the current color when the
switch was operated.