Troubleshooting - Silvercrest SBP 1960 A1 Bedienungsanleitung Und Sicherheitshinweise

Troubleshooting

This section contains important information on troubleshooting . If you are unable to solve the
problem by following the steps below, please contact Customer Service .
Fault Possible causes
The appliance is not
connected to the power
supply .
The appliance is
The device is not
not working .
switched on .
The appliance is
defective .
The appliance
The appliance has
interrupts the
overheated . This is due
drying process
to overloading or
during operation,
because the blower 6
and the timer
is blocked .
continues to run .
The set drying time has
expired .
The appliance
simply switches
itself off during
The appliance has fallen
operation .
over .
SBP 1960 A1
Possible solutions
Make sure that the mains plug is connected to
a suitable socket .
Turn the dial 9 clockwise until the desired
drying time is reached .
Contact the Customer Service department .
Turn off the timer . Otherwise, the appliance
will resume the drying process automatically
as soon as it has cooled down sufficiently and
if the set time has not already elapsed .
If necessary, remove the blockage from the
blower 6 . Allow the appliance to cool down
for approx . 5 –10 minutes and set a new
drying time . If the appliance still does not
start, turn off the timer and try again later .
If necessary, set a new drying time .
The appliance switches off automatically if it
falls over during operation . Stand it up and
turn it back on . Always ensure that it is
standing stably .
GB │ IE │ NI │ 13 ■