Starting The Dell Diagnostics From The Optional Drivers And Utilities Cd - Dell latitude 110l Schnellstartanleitung

• If a failure is detected, the computer stops and beeps. To stop the assessment and restart
the computer, press <n>; to continue to the next test, press <y>; to retest the
component that failed, press <r>.
• If failures are detected during the Pre-boot System Assessment, write down the error
code(s) and contact Dell before continuing on to the Dell Diagnostics.
If the Pre-boot System Assessment completes successfully, you receive the message
Dell Diagnostic Utility Partition. Press any key to continue
6 Press any key to start the Dell Diagnostics from the diagnostics utility partition on your hard
drive.

Starting the Dell Diagnostics From the Optional Drivers and Utilities CD

1 Insert the Drivers and Utilities CD.
2 Shut down and restart the computer.
When the DELL logo appears, press <F12> immediately.
If you wait too long and the Windows logo appears, continue to wait until you see the
Windows desktop. Then shut down your computer and try again.
NOTE:
The next steps change the boot sequence for one time only. On the next start-up, the computer
boots according to the devices specified in system setup.
3 When the boot device list appears, highlight CD/DVD/CD-RW Drive and press <Enter>.
4 Select the CD/DVD/CD-RW Drive option from the CD boot menu.
5 Select the Boot from CD-ROM option from the menu that appears.
6 Type
to start the ResourceCD menu.
1
7 Type
to start the Dell Diagnostics.
2
8 Select Run the 32 Bit Dell Diagnostics from the numbered list. If multiple versions are listed,
select the version appropriate for your computer.
9 When the Dell Diagnostics Main Menu appears, select the test you want to run.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 1 / 2 7 / 0 5 – F O R P R O O F O N LY
22
Quick Reference Guide
FILE LOCATION: J:\DL\DL044470\DTP\X7598eb0.fm
Booting
.