Toshiba REGZA XV50 ANALOGUE-Serie Bedienungsanleitung Seite 34

PROBLEM SOLVING
Q
Why are there problems with text?
A
Good performance of text depends on a good strong
broadcast signal. This normally requires a roof or loft
aerial. If the text is unreadable or garbled, check the
aerial. Go to the main index page of the text service
and look for the User Guide. This will explain the basic
operation of text in some detail. If further information
is needed on how to use text see the text section.
Q
Why are there no text sub-pages?
A
There are none broadcast or they have not yet loaded.
l
Press the button to access.
(See text section).
Q
Why are the four coloured text numbers visible but
no text?
A
Text has been selected whilst viewing an external
source i.e. DVD or VCR. No text will appear on screen
or a box may appear stating no information is
available. Select a broadcasting channel and press
TEXT to access.
Q
Why are the LEDs on the front of the television
flashing?
A
Check the table below.
LED indication
Condition
LED-2 LED-1
OFF Green (Solid) The TV is operatin
OFF Red (Solid) Standby with Power-
Green Red (Solid)
(Solid)
OFF RED Blinks Power protect
0.5 sec cycle
OFF Red Blinks Abnormal operation
1 sec cycle of BUS line.
OFF 2 times Abnormal operation
flashing with (Initialization error).
2 sec interval
Solution
–
properly.
–
On
On timer
–
detection.
Turn OFF the TV and
unplug the power
cord. Plug the power
cord in again and turn
ON the TV.
LED-2 LED-1
Q
Why are the colours wrong when an NTSC source is
played?
A
Connect the source via a SCART lead and play.
Select Manual setting from the SET UP menu.
EXT2
Store
OK
Back
MENU
a
Set the Colour to Auto. and exit.
b
Go to the Picture settings menu and adjust the tint.
Q
Why don't the devices connected via HDMI operate
properly?
A
Make sure to use cables with the HDMI logo
(see page 9).
Some early HDMI equipment may not work properly
with the latest HDMI TV products, due to new standard
adoption. Try Lip Sync setting to Off.
Q
Why don't the REGZA-LINK devices work?
A
When the connected REGZA-LINK device does not
work correctly after you have changed settings of the
device, turn off your television and unplug the power
cord, then plug and turn on again.
Unplug the HDMI cable of the REGZA-LINK device and
lead again.
Q
Why is the REGZA-LINK logo still showing when
the equipment has been disconnected?
A
If the REGZA-LINK is disconnected the logo will
disappear after approximately one minute.
34
Manual setting
Colour system: Auto.
A V C R
Watch TV
EXIT