Electrical Safety - Stanley FatMax FMCW210 Bersetzung Der Ursprünglichen Bedienungsanleitung

ENGLISH
Do not open the charger.
u
$ Do not probe the charger.
u
The charger is intended for indoor use only.
Read the instruction manual before use.
Labels on tool
The following pictograms along with the date code are shown
on the tool:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Wear a dust mask.

Electrical safety

#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Stanley Fat Max Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Dust collection cassette
3. Sanding base
4. Finger attachment
5. Battery
Accessories
The accessories supplied with your sander depend upon the
model that you have purchased. All the accessories listed
below are available in our range. If you require an accessory
that is listed below but is not supplied with your sander please
visit our website at www.blackanddecker.eu.
The performance of your tool depends on the accessory used.
Stanley Fat Max accessories are engineered to high quality
standards and designed to enhance the performance of your
tool. By using these accessories you will get the very best
from your tool.
6
(Original instructions)
Item Description
240 grit sanding mesh.
For a fine finish for large detail sanding.
(Part Number - X39132-XJ)
120 grit sanding mesh.
For a medium finish for large detail
sanding.
(Part Number - X39127-XJ)
80 grit sanding mesh.
For a coarse finish for large detail
sanding.
(Part Number - X39122-XJ)
240 grit large detail sanding sheet
with two replacement tips.
For a fine finish for large detail sanding.
(Part Number - X31019-XJ)
120 grit large detail sanding sheet
with two replacement tips.
For a medium finish for large detail
sanding.
(Part Number - X31009-XJ)
60 grit large detail sanding sheet with
two replacement tips.
For a coarse finish for large detail
sanding.
(Part Number - X31039-XJ)
120 grit detailed finger sanding sheet.
For a medium finish for detailed sanding.
(Part Number - X3277-XJ)
Charging procedure (Fig. A)
Stanley Fat Max chargers are designed to charge Stanley Fat
Max battery packs.
Plug the charger (5) into an appropriate outlet before
u
inserting the battery pack (4).
Insert the battery pack (4) into the charger (5) as shown in
u
figure A.
The LED (5a) will flash indicating that the battery is being
u
charged.
The completion of charge is indicated by the LED (5a)
u
remaining on continuously.
The pack is fully charged and may be used at this time or
left on the charger.
Note: Recharge discharged batteries as soon as possible
after use or battery life may be greatly diminished. For longest
battery life, do not discharge batteries fully.