Din Rail Mount; Start-Up; Installation Instructions - HomeMatic IP HmIP-FAL230-C10 Installations- Und Bedienungsanleitung

figure 3).
• Use an appropriate drill to make the holes as il-
lustrated.
• Use the supplied screws and plugs to fasten the
floor heating actuator (see fig. 3).
5.2

DIN rail mount

For mounting the floor heating actuator to a DIN rail,
please proceed as follows:
• Place the floor heating actuator onto the DIN rail
(see fig. 4).
• Latch the floor heating actuator by pressing the
spring latches (E) upwards (see fig. 4).
• Make sure that the spring latches are completely
latched and that the device is seated solidly on
the rail.
6

Start-up

6.1

Installation instructions

Please read this entire section before starting to
install the device.
Please note! Only to be installed by persons
with the relevant electro-technical knowledge
and experience!*
Start-up
53