Power Button; Light Sensor; Mode Button - Winix Zero S Bedienungshandbuch

07. Filter Reset Button
After replacing the True HEPA Filter, use a small object
such as a paper clip, to press and hold the Filter
Reset Button for at least 5 seconds until the Filter
Replacement Indicator turns off.

08. Power Button

Turns the unit on or off. During the first 30 seconds
of powering up, the Air Quality Indicator will cycle
through Blue, Amber and Red colors.
• Dust Sensor takes approximately 30 seconds to
gauge the air quality in the environment before
normal detect begins.

09. Mode Button

Press to cycle through to set the mode of operation
(Auto, Sleep). The unit will default to Auto with
®
PlasmaWave enabled when first powered on.
Auto Mode:
• Auto Mode automatically adjusts fan speeds
according to your indoor air quality. The fan speed
will adjust to low when air quality is good, medium
when fair, and to high when poor.
Sleep Mode:
When Sleep Mode is activated, the Air Quality
Indicator LED light is disabled.
• Fan speed will automatically set to minimum speed
(lower than 'Low') which will be nearly silent.
• When Sleep Mode is active, PlasmaWave
disabled, but it can be turned back on.
English
10. PlasmaWave
Press the Plasmawave
on to enable or disable this feature. By default,
PlasmaWave
powered on.
"When the unit is running, you may hear a chirping
or buzzing sound. The sound is from large particles
passing through PlasmaWave
not signify product failure."

11. Light Sensor

Detects the amount of ambient light in the
environment. When in Auto Mode, the Light Sensor
detects when to put the unit into Sleep Mode.
® will be
®
Button
®
button when the unit is
® is enabled whenever the unit is
®
, it is normal and does
Zero S 5