Whirlpool AGB 669/WP Gebrauchsanweisung Und Installation Seite 25

11 PROBLEMS AND ANOMALIES (USER)
PROBLEM
THE LED POWER INDICATOR
DOES NOT TURN ON
THE WASH PROGRAM DOES
NOT START
POOR WASHING RESULTS
RINSE INSUFFICIENT
GLASSES AND SILVERWARE
ARE STAINED
WATER IS PRESENT IN THE
TANK AFTER DRAINING
After having turned the machine off and on again, if the problem persists communicate the type of error displayed
on the screen to technical assistance:
E1 Boiler sensor malfunction
E2 Tank sensor malfunction
Water loading timeout ( the water loading duration has exceeded the time set in P9 )
E3
Draining anomaly. At the end of the draining phase the CPU still detects water in the Tank. This may be
due to: Drain pump malfunction, Drain tube blockage, Tank Pressostat malfunction, Drain cycle time set
E6
too low
30 minute Tank timeout
E7
E8 15 minute boiler timeout
13
POSSIBLE CAUSE
There is no electrical current
The dishwasher has not finished
loading
Sprinkler wash holes are clogged
or encrusted
Detergent or rinse-aid insufficient
or not adequate
Plates / glasses poorly positioned
Low wash temperature
Inadequate cycle setting
Sprinkler nozzles clogged
Calcium encrustations in the
boiler
Rinse-aid inadequate or not
dispensed correctly.
Water is of a hardness level
above 12°dF or contains many
dissolved salts
Drainage tube is positioned poorly
or is partially blocked
12 SCREEN DISPLAYED ANOMALIES (USER)
POSSIBLE REMEDY
Verify the electrical current connection.
Wait for the led indicator to
turn on
Disassemble and clean the sprinklers
(10.2 Periodic checks)
Verify detergent type and quantity.
Arrange plates / glasses accordingly.
Verify the temperature shown on the
display, if below 50°C call Assistance.
Increase the duration of the wash
cycle, particularly if dishes are very
dirty or contain partially dried residues.
Verify the cleanliness of the nozzles
and the correct function of any
installed water softeners.
Verify the rinse-aid container and
ensure its adequacy for use with the
water supply. If the problem persists
contact assistance.
Verify that the dishwasher's tube and
drain are not blocked and that the
drain is not in too high of a position;
see the connection diagram.