Building In - Zanussi zgg 643 Bedienungsanleitung

Building In

These hobs can be inserted in a built-in kitchen unit
whose depth is between 550 and 600 mm. The hobs
dimensions are shown in Fig. 9.
The edge of the cut out must have a minimum distance
from the rear wall of 55 mm.
If there are side walls, or sides of the furniture unit near
the hob, the cut out edges must have a minimum
distance of 150 mm.
Hanging forniture units or hoods must be placed at 650
mm. minimum from the hob.
Fitting the hob to the worktop
Before fitting the hob into the cut out, an adhesive seal
must be fitted to the underside outside edge (Fig. 9) of
the hob. It is essential that no gaps are left in this seal
in order to prevent spillage near the hob seeping into
the cabinet below.
1) Remove the pan supports, the burners caps and
crowns and turn the hob upside down, taking care the
ignition candles are not damaged in this operation.
2) Place the sealing gasket all around the glass top
edge as shown in Fig. 9.
3) Place the hob in the cut out, taking care that it is
centred. Fix the hob with the relevant fixing clamps,
supplied with the injectors kit (Fig.10). When the screws
have been tightened, the excess seal can be removed.
A = Auxiliary burner
SR = Semirapid burner
R = Rapid Burner
Dimensions are given in
millimeters
SR
SR
R
FO 2340
FO 2320
FO 2321
A
Fig. 8
Fig. 9
sealing
gasket
Fig. 10
41