Klarstein CLEANBUTLER 3G TURBO Handbuch Seite 21

Cleaning the cyclone cone system
1. Hold the filter unit firmly and turn it anti-clockwise. After turning, pull the
filter unit out to separate it from the cyclone cone.
2. Remove the individual components of the filter unit. Carefully tap the filter
wadding, the filter unit and the cyclone cone over the bin to remove any
accumulated dust. If necessary, the filter system can be cleaned with water.
Please note that the filter system must be completely dry before being used
again.
3. Reinsert the filter unit and turn it clockwise to secure it in place.
4. After the filter unit has been reinserted into the dust collector, you can
reconnect it to the device housing as described in the section "Attaching /
removing the dust collector".
5. Remove the sponge insert in the motor and carefully tap it over the bin to
remove any build-up of dust. If necessary, the sponge insert can be rinsed off
with clean water. Please note that this must be completely dry before being
used again.
Cleaning the floor brush
1. To remove the floor brush, press the release button on the floor brush.
Remove the roller brush by simultaneously pressing the floor brush down
towards the roller brush and clean it.
2. Place the roller brush back into the device after cleaning.
EN
21