Getting Started; Playing Discs; Basic Playback Controls - Pioneer D6 Bedienungsanleitung

04

Getting started

Chapter 4
Getting started
Switching on
After making sure that everything is connected
properly and that the player is plugged in, push
the POWER button into the ON position to
switch the player on.
• Press CD PLAYER  on the remote to
switch the unit into standby.
POWER
POWER
STANDBY
OFF ON PURE AUDIO

Playing discs

The basic playback controls for playing CDs,
SACDs, and MP3/WMA discs are covered
here. Further functions are detailed in Other
playback features on page 13.
1 If the player isn't already on, press
POWER to switch it on.
12
En
OFF ON
CD PLAYER CD PLAYER OPEN/CLOSE OPEN/CLOSE
TIME DIMMER
LEGATO
LINK
SACD/CD PURE AUDIO PURE AUDIO
1 1 2 2 3 3
4 4 5 5 6 6
7 7 8 8 9 9
0 0
CLEAR ENTER ENTER
Press  (OPEN/CLOSE) to open the disc
2
tray.
3 Load a disc.
Load a disc with the label side facing up, using
the disc tray guide to align the disc. Once
properly seated, press  to close the disc tray.
Press  (play) to start playback.
4

Basic playback controls

The table below shows the basic controls for
playing discs.
Button What it does

Starts playback.

Pauses a disc that's playing, or
restarts a paused disc.
/
Starts playback/stops a disc that's
playing.
(front panel
only)
• While depressing /, press 
(front panel only). Counting from the
first track on the disc, playback will
begin from the track number
corresponding to the number of
times  is pressed.

Stops playback.

Press to start fast reverse scanning.

Press (play) to resume normal
playback.

Press to start fast forward scanning.

Press (play) to resume normal
playback.