• "RUN"
Power indicator
•
button
To turn the appliance on or off.
Press and hold this button for around 3 seconds.
•
button
Inner lighting control button
• Display
Electronic temperature display
•
button
+ temperature setting button
•
button
- temperature setting button
• You can choose the desired chamber temperature by using the "
selected increases/decreases by 1°C with each button press.
Temperatures between 5 and 20°C or between 5 and 10°C / 10 and 20°C (depending on the model) can
be selected. Once the desired temperature has been selected, the display will flash for 5s before showing
the current internal cooler temperature. The set temperature can be viewed at any time by pressing and
holding the temperature select buttons for 5s.
In the event of a power cut, all previously selected temperature settings will be deleted and each chamber
will re-initialize to the factory-preset temperature of 12°C.
When the surrounding temperature is 25℃ and the wine cooler has no bottle loaded, it will take
around 30 minutes to increase the wine cooler's temperature from 5℃ to 12℃. Under the same
circumstance, it will take around 30 minutes to decrease the wine cooler's temperature from 12℃
to 5℃. The less the temperature span is, the less time it will take. The setting temperature of upper
zone should be lower than the setting temperature of lower zone
Function instruction
• Temperature alarm:
If inner temperature is higher than 23°C after running 10 hours with power, the "HI" is shown in display
panel, and the buzzer alarm after one hour continuously. It informs that the inner temperature is too
high, please check the reason. If inner temperature is lower than 0°C, the "LO" is shown in display panel,
and the buzzer alarm too will sound.
• Temperature recollection function:
In the event of a power interruption, wine cabinet will remember the previous temperature settings and
when the power is recovered, the cabinet temperature will go back the same setting temperature as
power off.
/
" buttons. The temperature
43