Routine Cleaning; When White Streaks Appear On Prints (Cleaning The Dust Proof Glass); When White Streaks Appear On Prints; (Cleaning The Dust Proof Glass) - Canon imageRUNNER ADVANCE C350P Handbuch Für Starter

Routine Cleaning

If streaks appear on printouts, the inside of the machine may be dirty. Clean the machine while referring to
the following. For high-quality printouts, we recommend cleaning these parts once or twice a month.
WARNING
When cleaning the machine, first turn Off the main power switch, and disconnect the power cord. Failure to observe
)
these steps may result in a fire or electrical shock.
Disconnect the power cord from the power outlet regularly, and clean the area around the base of the power plug's
)
metal pins and the power outlet with a dry cloth to ensure that all dust and grime is removed. If the power cord is
connected for a long period of time in a damp, dusty, or smoky location, dust can build up around the power plug
and become damp. This may cause a short circuit and result in a fire.
IMPORTANT
Do not use alcohol, benzene, paint thinner, or other solvents for cleaning. Doing so may result in damage to the
)
plastic parts.

When White Streaks Appear on Prints

(Cleaning the Dust Proof Glass)

When white streaks or other print defects occur, the dust
proof glass may be dirty. Follow the procedure below to
clean the dust proof glass.
01
Open the front cover of the main unit.
02
Remove the dust proof glass cleaner
from the rear side of the front cover of the
main unit.
58

Routine Cleaning

03
Hold the dust proof glass cleaner so
that the pad on the tip is facing down, insert
it in the locations shown on the illustration
until it stops, and then move it gently back
and forth.
Clean the four locations as shown below. There are
marks on the main unit that indicate the cleaning
locations. Check these marks when cleaning the dust
proof glass.
04
When you have finished cleaning the
dust proof glass, gently push the dust proof
glass cleaner back onto the rear side of the
front cover of the main unit.
Place the dust proof glass cleaner back on the rear
side of the front cover of the main unit with its tip
facing the left direction.