Samsung SOC-222 Montageanleitung Seite 6

4. Make a groove at the bottom of the base camera
with a knife so that the RJ-45 connector cable
goes out of the camera along the wall. (Choose
E
one out of 6 points at least 0.5mm thick.)
5. Put the RJ-45 connector cable to be connected
to the camera through the center hole of the
base camera. Insert the RJ-45 connector cable
into the groove to enable the camera to go out
along the wall.
6. Fix the assembly bracket camera in a hole on the wall or ceiling for installation.
Align the camera installation hole with the hole with a plastic anchor inserted into and
tap an assembly screw (TH M4 x 30) at 2 points.
7. Turn the screw inside the assembly bracket
assembly bracket camera counterclockwise with
a cross-headed driver to loosen a little.
10
CAMERA- BRACKET
HOLE
RJ - 45 CONNECTOR CABLE
HOLDER-REAR
8. Move the holder rear to control the direction.
9. Turn the screw inside the assembly bracket
camera with a cross-headed driver to tighten.
10.Turn the side screw machine (BH M2.6) in
the camera main body counterclockwise to loosen. Then, lift it a little and push it
in the arrow direction to separate the assembly case front and case rear.
11. Assemble the camera to the RJ-45 jack in the rear part of the camera main
body.
12. Put the bottom hole of the assembly
bracket camera and case rear in the
square groove as shown in the figure so
that the case rear can be hooked by the
assembly bracket camera hook.
(Be sure to lift the case rear a little bit
before inserting.)
CASE-FRONT
BH M2.6
CASE-REAR
11
E