Emptying The Filter Base - Kokido EV50 Bedienungsanleitung

 DO NOT use the pool vacuum without an intact filter cone in place.
Using your pool vacuum without an intact filter cone in place will VOID
your warranty.
DO NOT cover the side slot of the vacuum during operation. The

impeller /motor may be damaged as a result.
 DO NOT leave the pool vacuum in the water when it is not in use.
1) B ring your pool vacuum to the side of your pool / spa. Immerse the pool vacuum in
water and turn the power ON/FF switch to the ON position to initiate operation.
CAUTION! Make sure the pool vacuum is always facing downwards when it is placed
into the pool/spa. Otherwise it may bend the pole connector and damage it during the
process.
1) To remove the pool vacuum from the pool / spa, lift the pool vacuum while pointing it
downwards in order to allow water to escape from the outlet valve. Water is going to
escape via the handle / pole connector and draining holes inside the handle chamber
on the rear body.
CAUTION! Make sure the pool vacuum is always facing downwards when it is removed
from the pool/spa. Otherwise, the pole connector may be bent and damage the pool
vacuum in the process
2) Rinse the pool vacuum with fresh water after every use. DO NOT use any detergent.
EMPTYING THE FILTER
WARNING! Using the pool vacuum without a filter cone in place will
VOID your warranty.
In order to maximize the cleaning efficiency, be sure to clean the filter cone before and
after each use.
CAUTION! If the pool vacuum is charging, disconnect the external adaptor from the
power source and detach the pool vacuum from the charging base. Make sure the pool
vacuum is OFF

Emptying filter cone
1. Place the pool vacuum on a stable surface.
2. Turn the locking knob (on each side) anticlockwise until it is pointing towards the
green marking to unlock and release the transparent canister. Remove the
transparent canister from the rear body.
15