Stand-By Function - IKEA TVÄTTAD Handbuch

ENGLISH
programme to drain the water and
then touch the Start/Pause
End of the programme
When the programme has finished, the
appliance stops automatically. The acoustic
signals operate (if they are active). The
display shows
The indicator of the Start/Pause
goes off.
The door unlocks and the indicator
off.
1. Press button On/Off
appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the appliance
again, the display shows the end
of the previous programme. Turn
the programme knob to set a new
cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser drawer slightly ajar to prevent
mildew and odours.
Draining water out after end of cycle
If you have chosen a programme or an
option that does not empty out the water of
the last rinse, the programme is completed,
but:
• The time area shows
display shows the door locked
• The indicator of the Start/Pause
button starts flashing.
• The drum still turns at regular intervals to
prevent creases in the laundry.
• The door stays locked.
• You must drain the water to open the
door:
button.
button
goes
to deactivate the
and the
.
1. If necessary, touch the Spin
decrease the spin speed proposed by the
appliance.
2. Press the Start/Pause
appliance drains the water and spins.
The option indicator
If you have set
speed has not been changed,
when you press the Start/Pause
button, the appliance only
drains the water.
3. When the programme is completed and
the door locked indicator
you can open the door.
4. Press the On/Off
seconds to deactivate the appliance.

Stand-by function

The Stand-by function automatically
deactivates the appliance to reduce the
energy consumption when:
• You do not use the appliance for 5
minutes when no programme is running.
Press the On/Off
appliance again.
• 5 minutes after the end of the washing
programme.
Press the On/Off
appliance again.
The display shows the end of the last
programme.
Turn the programme knob to set a new
cycle.
If the pris programme knob rotated to the
"Reset" position
automatically turns off in 30 seconds.
If you set a programme or an
option that ends with water in the
drum, the Stand-by function
doesn't deactivate the appliance
to remind you to drain the water.
button to
button: the
or goes off.
and the spin
goes off,
button for a few
button to activate the
button to activate the
, the appliance
25