Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level; Selecting A Sanding Sheet; Fitting The Sanding Sheet - Parkside PAEXS 20-Li A1 Originalbetriebsanleitung

Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
♦ Push the battery pack
clicks into place .
Removing the battery pack
♦ Press the release button
battery pack .

Checking the battery charge level

♦ To check the battery status, press the battery
charge level button
will be shown on the battery display LED
follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Selecting a sanding sheet

Removal and surface
The material removal rate and surface quality are
determined by the grain strength of the sanding
sheet .
♦ Please note that you need to use appropriate
sanding sheets with different grains for working
different materials .

Fitting the sanding sheet

WARNING!
► Remove the battery pack before carrying out
any work on the appliance .
NOTE
► Before fitting a new sanding sheet
any dust and dirt from the sanding plate
■ 8 │ GB │ IE │ NI
into the handle until it
and remove the
(see fig . A) . The status
as
, remove
.
Attaching sanding sheets using Velcro
♦ You can attach the sanding sheet
sanding plate using the Velcro .
♦ Make sure that the extraction holes on the
sanding sheet match up with those on the
sanding plate .
Removing sanding sheets fitted using Velcro
♦ Simply pull the sanding sheet
plate .

Dust extraction

WARNING! RISK OF FIRE!
► There is a risk of fire when working with
power tools fitted with a dust collection box
or which can be connected to a vacuum
cleaner via the vacuum cleaner adapter! In
unfavourable conditions, e .g . when sparks
are flying while sanding metal or metal resi-
dues in wood, wood dust in the dust sack (or
in the vacuum cleaner dust bag) can sponta-
neously ignite . This is a particular risk if the
wood dust is mixed with paint residues or
other chemicals and the workpiece has
become hot after being worked for a long
time . Therefore, do not allow the workpiece
to overheat and always empty the dust box
or the dust bag in the vacuum cleaner before
taking a break from work .
Wear a dust mask!
NOTE
► Perforated sanding sheets are required for
dust extraction .
to the
off the sanding
PAEXS 20-Li A1