Zenoah BCZ260L Bedienungsanweisung Seite 9

5. Start the product (see instructions under
the product for start (BCZ260L, EXZ260L, BCZ300L)
on page 16 ) and apply full throttle.
6. Release the throttle and make sure that the cutting
attachment stops and remains at a standstill. If the
cutting attachment rotates with the throttle in the idle
position the carburettor idle setting must be checked.
See instructions under the chapter
page 19 .
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
sure that the engine stops.
To do a check of the cutting attachment guard
WARNING: Do not use a cutting attachment
without an approved and correctly attached
cutting attachment guard. See
on page 26 .
WARNING: Always use the recommended
cutting attachment guard for the cutting
attachment that you use. If an incorrect or
faulty cutting attachment guard is fitted this
can cause serious personal injury. See
intructions under heading
page 23 .
353 - 003 - 06.01.2018
To prepare
The cutting attachment guard prevents injuries from
objects that eject in the direction of the operator. It also
prevents injuries that occur if you touch the cutting
attachment.
Maintenance on
1. Make sure that the cutting attachment guard is not
2. Replace the guard if it has been exposed to impact
To do a check of the vibration damping system
Note: Use of incorrectly wound cord or an incorrect
cutting attachment increases the level of vibration. See
instructions under
heads on page 12 .
The vibration damping system decreases vibration in the
handles to a minimum which makes the operation
easier. The vibration damping system of the product
reduces the transfer of vibration between the engine unit
and the shaft unit of the product.
(BCZ260L, EXZ260L, BCZ300L)
Accessories
Technical data on
damaged or cracked.
or is cracked.
Assembly of blades and trimmer
9