LENCO PDR-040 Bedienungsanleitung Seite 24

10.5. Disconnect a paired device (to enable pairing a new device)
10.5.1. Long press the "Rotary button (07)"button to disconnect the
Bluetooth connection directly. The Lenco PDR-040 will switch to
Bluetooth pairing mode.
- Display shows: <Bluetooth Searching>.
10.5.2. Now you can pair the Lenco PDR-040 with another external BT
device.
Note: In Bluetooth mode, this device will automatically go into standby
mode 15 minutes later if no external Bluetooth device is connected or no
operation activity.
11. Troubleshooting
If a fault occurs, first check whether you can resolve the problem yourself.
You might find this overview useful.
CAUTION!
Risk of injury!
Opening the device can cause injuries.
Fault
No function
No sound
No/bad radio
reception
No Bluetooth®
connection
Possible cause/action
- If the device has been disrupted by a
thunderstorm, a static charge or another
external factor, follow this procedure to resolve
the problem: Power off this device and power on
it again 10 seconds later.
- Disconnect the supplied adapter and then plug it
in again.
- The volume may be set too low or in mute mode.
- In Bluetooth mode: Set the volume of the
external device to the maximum and then
control the volume by using "Rotary button
(07)".
- If necessary, select another location to improve
the radio signal.
- Adjust the telescopic antenna to optimize the
radio reception.
- Take care to ensure that all settings have been
made correctly on all devices. The Bluetooth®
function may be deactivated on the external
device. (re) activate it, if necessary.
- Check whether the device to be connected is
switched on and is in search mode.
24