Setting Up The Water Softener - KKT KOLBE GS60ED Benutzerhandbuch

Using the dishwasher

3.3 Setting up the water softener

The water softener has to be set manually. This feature is built in
your device to remove minerals and salt from the water, which
would have a detrimental or adverse effect on the operation of the
appliance. The higher the amount of these particles, the harder the
water is. The softener should be adjusted according to the hardness
of the water in your area of living. Inform yourself at your local water
authority about these values.
Adjunstment:
The amount of salt can be adjusted from H0 to H7.
At the set value H0 no salt is needed.
1. Find out the hardness of your tap water. Your water supplier will help you.
2. The set value can be found in the water hardness table.
3. Close the door.
4. Switch on the on / off switch.
5. Keep the „delay" button pressed and then press the „Start/Pause" button for 5 se-
conds. The buzzer will sound once and the indicator lamp will light up.
(See table for water hardness and status of the indicator lamp: Factory setting is H4.)
To change the setting:
1. Press the „Delay" button.
Each time the button is pressed, the set value increases by one stage.
When the value of H7 has been reached, the value is set back to H0 (off).
2. Press the „Start/Pause" button. The chosen setting was saved.
°Clark hard- Mmol/l
ness
0–8 soft 0–1.1
9–10 soft 1.2–1.4
11–12 medium 1.5–1.8
13–15 medium 1.9–2.1
16–20 medium 2.2–2.9
21–26 hard 3.0–3.7
27–38 hard 3.8–5.4
39–62 hard 5.5–8.9
Status der Kontrollleuchten
value
—
LED 3Std. LED 6Std. LED 9Std.
H0 Light Light
H1 Light Light
H2 Light Flash
H3 Light Flash
H4 Flash Light
H5 Flash Light
H6 Flash Flash
+
H7 Flash Flash
Light
Flash
Light
Flash
Light
Flash
Light
Flash
53