Transport And Storage; Assembly; Required Tools - Bosch Rexroth LTS350D Bedienungsanleitung

26/88 Bosch Rexroth AG
5

Transport and storage

For storing and transporting the product,
always observe the ambient conditions
specified in the technical data (see
"Technical data" on page 29).
6

Assembly

When installing the product, always observe
the ambient conditions specified in the
technical data (see "Technical data" on
page 29).

Required tools

• Screwdriver (size 0.8 x 4.5 mm)
Assembling the LTS350D/LTE350D
servo amplifiers
CAUTION
Risk of damage to persons and
property!
Assembly of the LTS350D/LTE350D servo
amplifiers requires basic mechanical and
electrical knowledge.

Only qualified personnel (see "Person-
nel qualifications" on page 19) are
authorized to assemble the LTS350D/
LTE350D servo amplifiers.

Measures to prevent electrostatic
discharge (ESD protection) must be
undertaken to protect the module and
system components during all assem-
bly work.
LTS350D/LTE350D |
Risk of injuries when assembling
under voltage!
If you do not switch off the power supply
before assembling the LTS350D/LTE350D
servo amplifiers, you may be injured or the
device or system components may be da-
maged.

1. Switch off the power supply for the
BT356 card rack or SB35x system box
and allow for a discharging time of
10 seconds.
2. Completely insert the LTS350D/
LTE350D servo amplifier into the respec-
tive slot in the BT356 card rack or SB35x
system box.
3. Tighten the knurled bolts on the front.
Make sure that the front panel is flush to
the BT356 card rack or SB35x system
box by tightening the knurled bolts.
3 608 870 0D6/2011-12
CAUTION
Always switch off the power supply for
the relevant system component before
assembling the LTS350D/LTE350D
servo amplifiers.