Resetting To The Factory Default Settings - Eneo IEB-63F0037M0A Schnellinstallationsanleitung

Resetting to the factory default settings

To reset the network camera to the original factory settings, go to the Setup > System >
Maintenance web page (described in "System > Maintenance" of Users Manual) or use the
Reset button on the network camera inside the bottom cap.
Reset Button
Using the Reset button:
Follow the instructions below to reset the network camera to the factory default settings
using the Reset button.
1. Switch off the network camera by disconnecting the power adapter.
2. Open the camera housing.
3. Press and hold the Reset button with a straightened paperclip while reconnecting
the power.
4. Keep the Reset button pressed until the Status indicator blinks.
5. Release the Reset button.
6. When the Power Indicator changes to Green (may take up to 40 seconds), the
process is complete and the network camera has been reset.
7. The network camera resets to factory default and restarts after completing the
factory reset.
8. Close the camera housing tightly to ensure waterproofness.
microSD Card Slot
EN
11