JANE Montecarlo R1 Bedienungsanleitung Seite 27

Choosing where to install the safety seat
Choosing the correct place to install the safety seat in the vehicle can
reduce the risk of injury to the child in the event of an accident. If pos-
sible the safety seat should be installed on the back seat of the vehicle.
There are two possible installations:
1. With Isofix anchors and the 3-point seat belt; follow the instruc-
tions in the "semi-universal" section below. Remember that for this
safety seat the ISOfix anchors are only used to give the seat greater
stability, in the event of an accident the child is restrained with the
3-point seat belt. Also bear in mind that it is "Semi-universal" and
not all vehicle seats are compatible, consult the Vehicle List included
in a leaflet with the instructions or go straight to our web page
www.jane.es/
2. Just with the 3-point seat belt; follow the instructions in the "Uni-
versal" section. In other words, it is compatible with most vehicle
seats. However, whenever the vehicle manufacturer states that the
seats are suitable for "Universal" type car safety seats this means it
is fully compatible.
Raise or remove the vehicle headrest if it interferes with the safety
seat headrest.
On seats fitted with a frontal air-bag, move the seat as far back as
possible.
Installing your Montecarlo R1 in the vehicle
3 Semi-universal and Universal installation:
Semi-universal: with ISOfix anchors and the 3-point seat belt
The ISOfix anchors have been designed to safely and easily secure
child restraint systems. Not all vehicles are fitted with these an-
chors, although they are now generally standard in newer models.
Consult the enclosed leaflet to see the vehicle list stating in which
vehicles the safety seat can be correctly installed. An updated list
can be found on the JANÉ web page (www.jane.es).
ISOFIX
27