Polycom RMX 4000 Handbuch Seite 3

United States Federal Communication
Commission (FCC)
Part 15: Class A Statement. This equipment has
been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC
Rules. Test limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial environment.
This equipment generates, uses and can radiate
radio-frequency energy and, if not installed and used
in accordance with the instruction manuals, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference, in which case the
user will be required to correct the interference at his
or her own expense.
Part 68: Network Registration Number.
This equipment complies with Part 68 of the FCC
rules and the requirements adopted by the ACTA. On
the rear side of this equipment is a label that
contains, among other information, a product
identifier in the format US:AAAEQ##TXXXX. If
requested, this number must be provided to the
telephone company.
The telephone company may make changes to its
facilities, equipment, operations or procedures that
could affect the operation of the equipment. If this
happens the telephone company will provide
advance notice so you can make the necessary
modifications to maintain uninterrupted service.
Regulatory Notices
This equipment does not contain any user
serviceable part. If trouble is experienced with this
equipment RMX 4000, for repair or warranty
information, please contact Polycom Inc in the U.S.A.
If the equipment is causing harm to the telephone
network, the telephone company may request that
you disconnect the equipment until the problem is
resolved.
If, in the unlikely event that this equipment causes
harm to the network, the telephone company will
notify you in advance that temporary discontinuance
of service may be required. But if advance notice isn't
practical, the telephone company will notify you as
soon as possible. Also, you will be advised of your
right to file a complaint with the FCC if you believe it
necessary.
This registered equipment may not be used with party
lines or coin lines.
United States Safety Construction Details:
•
All connections are indoor only.
•
Unit is intended for RESTRICTED ACCESS
LOCATION.
•
Unit is to be installed in accordance with the
National Electrical Code.
•
The branch circuit overcurrent protection shall
be rated 20 A for the AC system.
•
This equipment has a maximum operating
ambient of 40°C, the ambient temperature in
the rack shall not exceed this temperature.
To eliminate the risk of battery explosion, the battery
should not be replaced by an incorrect type.
Dispose of used batteries according to their
instructions.