Display Illumination - Bosch GLM 30 Professional Originalbetriebsanleitung

OBJ_BUCH-2004-005.book Page 22 Friday, December 18, 2015 4:09 PM
22 | English
Briefly press the measuring button 2 to initiate the measurement.
The current measured value c appears in the bottom line of the
display. The laser beam is switched off.
To switch on the laser beam, briefly press the measuring button 2.
To initiate another measurement, briefly press the measuring but-
ton 2 again. The current measured value c is displayed in the bot-
tom line. The previous measured value b is displayed in the middle
line. In the top line, the auto-sum a (the sum of the current and
previous measured value) is displayed.
Switching the Sound On and Off (3 601 K72 5..)
Switch the measuring tool off.
Changing the Unit of Measure (3 601 K72 57.)
Switch the measuring tool off.

Display Illumination

The display illumination is continuously switched on. When no button is pressed, the
display illumination is dimmed after approx. 10 seconds to preserve the batteries/re-
chargeable batteries. When no button is pressed for after approx. 30 seconds, the
display illumination goes out.
1 609 92A 25N | (18.12.15)
Press and hold the measuring button 2. When the cur-
sor is on the desired setting, release the measuring
button 2. After releasing, the measuring tool switches
itself on with the selected setting.
Press and hold the measuring button 2. When the cur-
sor is on the desired setting, release the measuring
button 2. After releasing, the measuring tool switches
itself on with the selected setting.
Bosch Power Tools