Your New Appliance; Gas Burners - CONSTRUCTA CA16-Serie Gebrauchsanleitung

Your new appliance

Page 2 shows an overall view of your new appliance as well as
the burner power.
Accessories
Depending on the model, the hob may include the following
accessories. These can also be acquired from the Technical
Assistance Service.

Gas burners

There are indications to show which burner each control knob
operates.
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to work
correctly. Do not swap the burner caps around.
Additional wok pan support
Only for use on wok burners
with pans with a round base.
Using these pans may cause
some temporary deformation
of the grease drip tray. This is
normal and does not affect
the operation of the appli-
ance.
Additional coffee maker sup-
port
Only for use on the auxiliary
burner with pans which are no
more than 12 cm in diameter.
--------
Code
363300 Additional wok pan support
184200 Additional coffee maker support
648786 Simmer Plate
616229 Simmer Cap
The manufacturer accepts no liability if these accessories are
not used or are used incorrectly.
Switching on manually
Press the chosen burner control knob and turn it
1.
anticlockwise to the required setting.
Use any type of lighter or flame (cigarette lighter, matches,
2.
etc.) and bring it close to the burner.
Switching on automatically
If your hob can be switched on automatically (ignition
sparkers):
Press the chosen burner control knob and turn it
1.
anticlockwise to the maximum power setting.
While the control knob is still pressed down, sparks are
produced on all burners. The flame ignites.
Release the control knob.
2.
Turn the control knob to the required setting.
3.
If it does not come on, turn the control knob to the off setting
and repeat the steps above. This time, press and hold the
control knob for longer (up to 10 seconds).
:
Risk of deflagration!
If after 15 seconds the flame does not ignite, switch off the
burner and open a nearby window or door. Wait at least one
minute before trying to switch the burner back on.
Simmer Plate
This accessory has been
designed to reduce the level
of heat at the lowest power
setting.
Place the accessory directly
on the pan support with the
cones facing upwards, never
directly over the burner. Cen-
tre the pan over the acces-
sory.
Simmer Cap
Burner specially designed to
cook at minimum power. In
order to use it, remove the
auxiliary burner and replace it
with the Simmer Cap burner.
11