Maintenance And Care; Electrical Connection; Storage - Scheppach 5907803901 Original Bedienungsanleitung

• Have the appliance serviced whenever necessary.
• Switch the appliance off when it is not in use.
• Wear protective gloves.

9. Maintenance and Care

Before each maintenance and cleaning work:
• switch off device
• wait for standstill of the beater
• pull out power plug
Use only original parts. Other parts can result in un-
expected damages and injuries.
Maintenance and repair work beyond this is only al-
lowed to be carried out by the manufacturer or au-
thorized service staff.
Store unused equipment in a dry, locked place out
of the reach of children.
Observe the following to maintain the operability of
the machine:
• Keep vent slits clean and free from obstructions.
• Remove dust and dirt using a cloth or a soft brush.
• Do not clean the machine with running water or
highpressure cleaners.
• Do not use solvents for the synthetic parts (petrol,
alcohol, etc.) as these can damage the synthetic
parts.
• Check that the handles are properly secured.
• Clean the beaters.
• The agitator is equipped with carbon brushes.
Have the carbon brushes be replaced by the cus-
tomer service if they are worn
Regularly check the beater for damages for your own
safety. Immediately replace any damaged beater. Al-
ways replace the beaters in pairs.
Check the shaft on a regular basis. An agitator with
defective shaft must no longer be used. Have the
device be repaired by the customer service.
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts* Mixing paddle, carbon brushes
* Not necessarily included in the scope of delivery!
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

10. Electrical connection

The electrical motor installed is connected and
ready for operation. The connection complies
with the applicable VDE and DIN provisions.
The customer's mains connection as well as
the extension cable used must also comply with
these regulations.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
This may have the following causes:
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been im-
properly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insula-
tion damage.
Check the electrical connection cables for damage
regularly. Make sure that the connection cable does
not hang on the power network during the inspection.
Electrical connection cables must comply with the
applicable VDE and DIN provisions. Only use con-
nection cables with the marking „H05VV­F".
The printing of the type designation on the connec-
tion cable is mandatory.
AC motor
• The mains voltage must be 220 - 240 V~
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm .
2
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data ­ type plate
• Motor data ­ type plate

11. Storage

• The whole machine and all accessories must be
thoroughly cleaned.
• Store the machine always out of children's reach.
Put it in a secure position in a dry and safe place
where no extremely high or extremely low tem-
peratures may occur.
GB | 21