Cleaning The Appliance; Descaling The Appliance - Silvercrest SEM 1100 C3 Bedienungsanleitung

NOTE
►

Cleaning the appliance

Clean the appliance with a moist cloth. If necessary, use a little detergent on the cloth.
Ensure that the appliance is completely dry before the next use.

Descaling the appliance

CAUTION! PROPERTY DAMAGE!
Do not generate steam when the descaler solution is in the water tank 9!
►
Descale the appliance regularly. The appliance should be descaled after about
1–2 months (if used to make approx. 4 espressos per day). This value can vary
depending on the hardness of the water in your region.
Proceed as follows to use the descaler s supplied with the appliance:
1) Add the descaler s (125 ml) to the water tank 9.
2) Fill the water tank 9 up to the Max mark with water and replace the tank
in the appliance.
3) Switch on the appliance using the On/Off switch 1. Make sure the steam
control 7 is shut off.
4) Insert the sieve holder i without any espresso sieve o p into the appliance.
5) Place 2 cups or a container capable of holding at least 250 ml under the
sieve holder openings.
6) As soon as the "Espresso" control lamp t lights up continuously, press the
"Espresso" button
Allow around 250 ml (around 2 cups) of descaler solution to run through
and then stop the process by pressing the "Espresso" button
Carefully pour out the used descaler solution.
7) Allow the descaler s to act for approx. 1 minute.
8) Repeat steps 6 to 7 three more times. Empty the water tank 9 completely
the last time.
9) Place a sufficiently large container (at least 1 litre) under the sieve holder
openings.
10) Rinse out the water tank 9 with fresh water and fill it with fresh water up to
the Max mark.
11) As soon as the "Espresso" control lamp t lights up continuously, press the
"Espresso" button
Allow the water to run through completely. Carefully pour out this water.
SEM 1100 C3
The two espresso sieves o p, the measuring spoon a and the
drip tray q are dishwasher-safe.
3.
3.
3 again.
GB │ MT │ 67 ■