Correct Use; Unpacking; Commissioning; Switching On - IKA KS 4000 i control Betriebsanleitung

Correct use

Use:
For mixing and/or heating liquids.
Range of use:
Indoor environments similar to that a laboratory of research, teaching, trade or
industry.
The safety of the user cannot be guaranteed:
- if the device is operated with accessories that are not supplied or recommended
by the manufacturer.
- if the device is operated improperly or contrary to the manufacture's specifications.
- if the device or the printed circuit board are modified by third parties.

Unpacking

Unpacking:
- Please unpack the device carefully.
- In the case of any damage a detailed report must be set immediately (post, rail
or forwarder).
Contents of package:
KS 4000 i control:
- Shaking device
- Mains cable
- Operating instructions
- 4 clamping screws short
- 2 clamping screws long
- Temperature sensor PT 1000.60
KS 4000 ic control:
- Shaking device
- Mains cable
- Operating instructions
- 4 clamping screws short
- 2 clamping screws long
- Temperature sensor PT 1000.60
- 2 hose connecting pieces
- unlocking handle

Commissioning

Make sure before start-up of the equipment that the drain hose leads into a drain!
Check whether the voltage specified on the type plate matches the mains voltage
available. The power socket used must be earthed (protective earth conductor
contact).
If these conditions are met, the device is ready to operate after plugging in the mains
plug. If these procedures are not followed, safe operation cannot be guaranteed
and/or the equipment may be damaged.
Observe the ambient conditions (temperature, humidity, etc.) listed under
"Technical Data".

Switching on

The appliance is switched on using the switch on the
side of the appliance. Once it has been switched on,
all of the LEDs light up briefly during the self test.

Display fields

Software
Operating
Version
mode

max.
Safety max.
adjustable
limit adjustable
temperature
values speed
Note the load guideline values for the attachments prior to switching
appliance on (see "Attachments").
Main switch I / 0
17