Ryobi RCS1935 Bedienungsanleitung Seite 5

Use extreme caution when cutting brush and
saplings. The slender material may catch the saw
chain and be whipped toward you or pull you off
balance.
Carry the chainsaw by the front handle with the
chainsaw switched off and away from your body.
When transporting or storing the chainsaw always
fit the guide bar cover.
with the moving saw chain.
Follow instructions for lubricating, chain tensioning
and changing accessories. Improperly tensioned
Keep handles dry, clean, and free from oil and
grease. Greasy, oily handles are slippery causing loss
of control.
Cut wood only. Do not use chainsaw for purposes
not intended. For example: do not use chainsaw
for cutting plastic, masonry or non-wood building
materials. Use of the chainsaw for operations different
than intended could result in a hazardous situation.
Causes and operator prevention of kickback:
touches an object, or when the wood closes in and pinches
the saw chain in the cut.
Tip contact in some cases may cause a sudden reverse
operator.
Either of these reactions may cause you to lose control of
the saw which could result in serious personal injury. Do
not rely exclusively upon the safety devices built into your
operating procedures or conditions and can be avoided by
Maintain a firm grip, with thumbs and fingers
encircling the chainsaw handles, with both hands
on the saw and position your body and arm to allow
you to resist kickback forces.
be controlled by the operator, if proper precautions are
Do not overreach and do not cut above shoulder
height. This helps prevent unintended tip contact and
enables better control of the chainsaw in unexpected
situations.
Only use replacement bars and chains specified
by the manufacturer. Incorrect replacement bars and
Follow the manufacturer's
maintenance instructions for the saw chain.
Decreasing the depth gauge height can lead to
ADDITIONAL CHAINSAW SAFETY WARNINGS
sharpening and
when operating the product the first time.
properly fitted and are in good condition.
to be physically fit. The operator should be alert, have
good vision, mobility, balance and manual dexterity. If
there is any doubt, do not operate the chainsaw.
Do not start using the product until you have a clear
away from the falling tree.
Beware of the emission of lubricant mist and saw dust.
Electric power should be supplied via a residual current
If the power cable becomes damaged, you must return
the machine to an authorised service centre for repair
or replacement.
area of cutting. Apart from the danger of electrocution,
untidy cables cause falls and trips.
Always hold the chainsaw with both hands when
operating the saw. Use a firm grip with thumbs and
fingers encircling the chainsaw handles. Right hand
must be on the rear handle and left hand on the front
handle.
contacting any object.
Do not modify your tool in any way or use it to power
any attachments or devices not recommended by the
manufacturer for your saw.
wound dressings and a means to summon attention
The operator may be tempted to remove the helmet if
remember the helmet, particularly with the mesh visor,
can help reduce the potential for injury to the face and
An incorrectly tensioned chain can jump off the guide
bar and could result in serious injury or fatality. The
simple cuts on securely supported wood. Do this
whenever you have not operated the saw for some
time.
–
leaving the product unattended
–
EN
English | 3