LaserLiner Centurium Express G Bedienungsanleitung Seite 25

Slope function > 4°
Steeper slopes can be set using the angle plate,
which is available as an optional extra.
TIP: Allow the device to align itself automatically
and set the angle plate to the zero position. Then
press the auto/man button to switch the automatic
sensor off. Finally, incline the device to the angle
you require.
Laser modes
Rotary mode
The following speeds can be set using the rotary
button: 0, 100, 400, 800 rpm
Spot mode
You access spot mode by pressing the rotary
button repeatedly until the laser stops rotating.
The laser can then be positioned exactly at the
measuring point by means of the direction
buttons.
Scan mode
The scan button can be used to activate and set
a lightintensive segment in 4 different widths.
You position the segment via the direction
buttons.
Hand receiver mode
Working with the laser receiver (available as an
optional extra): Set the rotary laser to maximum
speed and switch on the laser receiver. Refer to
the operating instructions for the respective laser
receiver about this.
Manual_Centurium_Express_G_Rev20W43_DE_FR.indd 25 Manual_Centurium_Express_G_Rev20W43_DE_FR.indd 25
Centurium Express G
man
25
EN
21.10.20 08:5 21.10.20 08:5