Tips For Saving Energy - Küppersbusch FKG9700.0E Bedienungsanweisung Mit Montageanweisungen

BEFORE CALLING SERVICE
IMPORTANT NOTES:
• Compressor protection function will be activated after sudden power breakdowns or after
unplugging the appliance, because the gas in the cooling system is not stabilized yet.
Your fridge will start after 5 minutes, there is nothing to worry about
• If you will not use your fridge for a long time (e.g. in summer holidays) unplug it. Clean
your fridge according to Part 4 and leave the door open to prevent humidity and smell.
• If the problem persists after you have followed all the instructions above, please consult
to the nearest authorized service.
• The appliance you bought is designed for home type use and can be used only at home
and for the stated purposes. It is not suitable for commercial or common use. If the
consumer use the appliance in a way that does not comply with these features, we
emphasize that the producer and the dealer shall not be responsible for any repair and
failure within the guarantee period.
• The lifetime of your appliance stated and declared by the Department of the Industry is 10
years (the period for retaining parts required for the proper functioning of the appliance).

6.1 Tips For Saving Energy

1. Install the appliance in a cool, well ventilated room , but not in direct sunlight and not near
a heat source (radiator, cooker.. etc). Otherwise use an insulating plate.
2. Allow warm food and drinks to cool down outside the appliance.
3. When thawing frozen food, place it in the refrigerator compartment. The low temperature
of the frozen food will help to cool the refrigerator compartment when it is thawing. This
will help to save energy. If the frozen food is put out, it results in a waste of energy.
4. Cover drinks or other liquids when placing them in the appliance Otherwise humidity
increases in the appliance. Therefore, the working time gets longer. Also covering drinks
and other liquids helps to preserve smell and taste.
5. Try to avoid keeping the doors open for long periods or opening the doors too frequently
as warm air will enter the cabinet and cause the compressor to switch on unnecessarily
often.
6. Keep the covers of the different temperature compartments (crisper, chiller ...etc ) closed
7. Door gasket must be clean and pliable. Replace gaskets if worn.
8. To save energy, set the night sensor is in active mode and the door handle LEDs are in
the OFF position.
EN - 30 -