Installation - MA lighting grandMA3 Kurzanleitung

Installation

Hint:
The grandMA3 I/O Node can be connected with the power cable. Only the grandMA3 I/O Nodes DIN-Rail need to be
installed on the rail following DIN EN 60715 and the instructions below.
Important:
Install the grandMA3 I/O Node DIN-Rail horizontally so that the input terminal is located at the bottom.
Warning:
In order for the device to dissipate heat, comply with a minimum distance of 30 mm (approx. 2 inches) above and beneath
the grandMA3 I/O Node DIN-Rail.
15
Intended Use
Safety
Support
Transport
Limitations
Installation
Quick Start
Maintenance
Disposal
Technical Data
Conformity