Transport, Packaging And Storage; Commissioning, Operation - WIKA A2G-10 Betriebsanleitung

4. Transport, packaging ... / 5. Commissioning, operation

4. Transport, packaging and storage

4.1 Transport
Check the instrument for any damage that may have been caused by transport.
EN
Obvious damage must be reported immediately.
CAUTION!
Damage through improper transport
With improper transport, a high level of damage to property can occur.
▶
▶
4.2 Packaging and storage
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change in
installation site, sending for repair).
Permissible conditions at the place of storage:
Storage temperature: 0 ... 70 °C
■
Humidity: 35 ... 85 % relative humidity (no condensation)
■

5. Commissioning, operation

5.1 Installation and mechanical connection
In accordance with the general technical regulations for pressure measuring instruments
(e.g. EN 837-2 "Selection and installation recommendations for pressure gauges").
air2guide standard gauges are calibrated in vertical position and should be installed in the
same position to avoid loss of class accuracy. If a different installation position is required
for air2guide instruments, please specify when ordering. Instruments with high measuring
ranges can be installed in a different, non-vertical mounting position by simply adjusting
the zero point.
8
When unloading packed goods upon delivery as well as during internal
transport, proceed carefully and observe the symbols on the packaging.
With internal transport, observe the instructions in chapter 4.2 "Packaging
and storage".
WIKA operating instructions models A2G-10, A2G-15