Decommissioning; Switching Off The Appliance; Taking The Appliance Out Of Service; Disposing Of The Appliance - Atag KD80102ADN Gebrauchsanweisung

Decommissioning

The compressor runs for longer in order to rapidly cool the
u
food. This is normal.
A LED on the bottom rear of the appliance (at the
compressor) flashes repeatedly every 5 seconds*.
→ There is a fault.
Please contact the after-sales service (see 6 Mainte-
u
nance) .
Excessive noise.
→ Due to the various speed steps, speed-regulated* compres-
sors can generate different running noises.
The sound is normal.
u
A bubbling and gurgling noise.
→ This noise comes from the refrigerant flowing in the refriger-
ation circuit.
The sound is normal.
u
A quiet clicking noise.
→ The noise is produced whenever the refrigeration unit
(motor) automatically switches on or off.
The sound is normal.
u
A hum. It is briefly a little louder when the refrigeration
unit (the motor) switches on.
→ The refrigeration increases
Fast-Cool function is activated, fresh food has just been
placed in the appliance or the door has been left open for a
while.
The sound is normal.
u
→ The ambient temperature is too high.
Solution: (see 1.2 Appliance range of use)
u
A low hum.*
The sound is produced by air flow noise of the fan.
→
The sound is normal.
u
Vibration noises
→ The appliance is not standing firmly on the floor. As a result
objects and adjacent units start to vibrate when the refriger-
ator is running.
u Check the installation and realign the appliance.
u Keep bottles and jars apart.
Flow sound at the soft stop mechanism.
→ The noise is produced when the door is opened and
closed.
The sound is normal.
u
The temperature display indicates:
→ There is a fault.
Please contact the after-sales service (see 6 Mainte-
u
nance) .
DEMO shines in the temperature display.
→ The demo mode is activated.
Please contact the after-sales service (see 6 Mainte-
u
nance) .
The outer surfaces of the appliance are warm*.
→ The heat of the refrigeration circuit is used to prevent
condensate from forming.
This is normal.
u
The temperature is not cold enough.
The door of the appliance is not properly closed.
→
Close the door of the appliance.
u
→ Insufficient ventilation.
Keep ventilation grille clear, and clean it.
u
→ The ambient temperature is too high.
Solution: (see 1.2 Appliance range of use) .
u
The appliance was opened too frequently or for too long.
→
Wait to see whether the appliance reaches the required
u
temperature by itself. If not, please contact the after sales
service (see 6 Maintenance) .
→ The temperature is incorrectly set.
24
automatically when the
to
F0 F9
Set the temperature to a colder setting and check after 24
u
hours.
The appliance is too close to a source of heat (stove, heater
→
etc).
Change the position of the appliance or the source of heat.
u
→ The appliance was not inserted properly into the recess.
Check whether the appliance was inserted correctly and
u
the door closes properly.
The internal light does not come on.
→ The appliance is not switched on.
Switch the appliance on.
u
→ The door was open for longer than 15 minutes.
The internal light switches itself off automatically after about
u
15 minutes if the door is open.
The LED illumination is faulty or the cover is damaged:
→
WARNING
Risk of injury due to electric shock!
There are live electrical parts under the cover.
u Only ever have the inside LED light replaced or repaired by
customer service or trained personnel.
WARNING
Risk of injury from LED bulb!
The light intensity of the LED light corresponds to hazard group
RG 2.
If the cover is defective:
u Do not look directly into the light from close range. It cause
injury to the eyes.
8 Decommissioning

8.1 Switching off the appliance

u Press On/Off button
approx. 2 seconds.
w A long beep is emitted. The temperature display
is dark. The appliance is switched off.
w If the appliance cannot be switched off, the child
lock function is active (see 5.1 Child proofing) .

8.2 Taking the appliance out of service

u Empty the appliance.
u Switch off the appliance (see 8 Decommissioning) .
u Remove mains connector.
u Clean the appliance (see 6.2 Cleaning the appli-
ance) .
u Leave the door open to prevent odour.

9 Disposing of the appliance

The appliance contains some reusable materials
and should be disposed of properly - not simply
with unsorted household refuse. Appliances which
are no longer needed must be disposed of in a
professional and appropriate way, in accordance
with the current local regulations and laws.
Do not damage the disused appliance while removing it from
the cooling circuit, in case the coolant (information on the
model plate) ) or oil inside leaks out.
For Germany:
* Depending on model and options
Fig. 2 (1)
for