Zulassungsinformationen; Zulassungsmodellnummer; Fcc-Erklärung - HP DeskJet Ink Advantage 2700 Benutzerhandbuch

Zulassungsinformationen

Der Drucker erfüllt die Produktanforderungen der Kontrollbehörden in Ihrem Land/Ihrer Region.
Dieser Abschnitt behandelt folgende Themen:

Zulassungsmodellnummer

●
FCC-Erklärung
●
Hinweise zur Verwendung des Netzkabels
●
Hinweis für Benutzer in Korea
●
Hinweis zur Geräuschemission (für Deutschland)
●
Europäische Union – Rechtlicher Hinweis
●
Hinweis zu Bildschirmarbeitsplätzen in Deutschland
●
Konformitätserklärung
●
Rechtliche Hinweise zu Wireless-Produkten
●
Zulassungsmodellnummer
Zu Identifizierungszwecken ist Ihrem Gerät eine Modellzulassungsnummer zugewiesen. Diese
Modellzulassungsnummer darf nicht mit den Produktnamen oder den Produkt-/Gerätenummern verwechselt
werden.
FCC-Erklärung
The United States Federal Communications Commission (in 47 CFR 15.105) has specified that the following
notice be brought to the attention of users of this product.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and the receiver.
●
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
●
Consult the dealer or an experienced radio/TV technician for help.
●
NOTE: If the product has an Ethernet / LAN port with metallic casing then use of a shielded interface
cable is required to comply with the Class B limits of Part 15 of FCC rules.
Modifications (part 15.21)
DEWW Zulassungsinformationen 109