Inhaltsverzeichnis
Werbung
Installation
The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range
hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers.
If the instructions for installation for the gas hob specify a greater distance, this must be adhered to.
Electrical connection
The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect
the hood to a socket in compliance with current regulations and positioned in an accessible area, after installation. If it not fitted with a
plug (direct mains connection) or if the plug is not located in an accessible area, after installation, apply a double pole switch in
accordance with standards which assures the complete disconnection of the mains under conditions relating to over-current category
III, in accordance with installation instructions.
Warning! Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains
cable is correctly assembled.
The hood is provided with a special power cable ; if the cable is damaged, request a new one from Technical Service.
Mounting
Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify
suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the
hood. Do not tile, grout or silicone this appliance to the wall. Surface mounting only.
30
Werbung
Inhaltsverzeichnis
